PX-CP-S2 button batteries punching machine an overview of the punching machine dedicated to the coin cell production process, positive and negative film or diaphragm rushed to take steps. High hardness mold, easy to use, durable, smooth edge without burr red material for universities and businesses experimental lines. Second, the principle of this process is punching machine operation, controlled by human hand rocker, slide and upper die driven downward momentum generated when the upper die spring clamp contact with the lower die, will be placed under the mold pole piece or diaphragm to suppress, the mold movement continue down the pole piece or cut into round slices diaphragm stamping die size size. A feeding device equipped with user-friendly, hand-holding force the material can handle a little out of the drawers pulled out of the mold will be finished, easy to operate. Third, the main features 1 easy to replace mold, simple operation; 2 neat appearance, user-friendly design with unloading drawers, punching pole pieces directly into the drawer, easy to remove after the completion of a one-time; 3 can be punched various battery materials 0.01 ~ 0.5mm thick; 4 punching high precision, no edges, burrs, indentation; 5 small size, can freely pass through more than 200mm in diameter over the glove box. Fourth, the technical parameters 1 Applicable Battery Type: all kinds AG, CR, LIR button batteries, 2032,2025,2016 and other models can be customized according to requirements; 2 mold material: high-quality tool steel, heat treated to HRC60 hardness; 3 Die Accuracy: ± 0.01mm; 4. overall dimensions: Approximately 166mm (length) × 196mm (width) × 233 mm (height); 5 Weight: about 15KG.